Hello William,
With this checkin command, the label was checked by reading it on the tape (not
with the barcode). There is no reason to lose data if the tape is ok.
You can check with the admin interface of the library if the barcode is
correctly seen by the interface.
If not, it's probably a problem with the barcode itself. So, you can change the
label or move data to another tape if you wants to be sure the tape is readable.
Best regards,
Julien
Julien Malghem
Ingénieur Système / Spécialiste Stockage
julien.malghem AT rbs DOT fr
2 Ter rue Marcel Doret
31700 Blagnac
www.rbs.fr
RBS Solutions
Tél. : +33 (0)5 34 47 76 77 • Portable : +33 (0)6 60 26 61 52 • Fax : +33 (0)5
34 47 14 14
Un problème ? Contactez le Centre de Support RBS au 0892 70 12 12 (0,34€/mn) ou
écrivez à support AT rbs DOT fr
Intéressé(e) par nos solutions ? Contactez notre service commercial à contact
AT rbs DOT fr
Intéressé(e) par notre programme de partenariat ? Contactez notre service
alliance à partners AT rbs DOT fr
Ce message et ses éventuelles pièces jointes sont établies à l'intention
exclusive de son ou de ses destinataires. Toute utilisation, diffusion ou
publication non autorisée est prohibée. Ready Business System SA décline toute
responsabilité au titre de ce message s'il a été altéré ou falsifié. Il ne
contient aucun virus, mais il est de la responsabilité de son destinataire de
s'en assurer.
Merci de n'imprimer ce message ou ses pièces jointes que si cela s'avère
nécessaire.
-----Message d'origine-----
De : ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] De la part de
William ZHANG
Envoyé : jeudi 10 juin 2010 03:51
À : ADSM-L AT VM.MARIST DOT EDU
Objet : Re: [ADSM-L] volume missed in library
And now I run command "checkin libvol LIBNEO4000 search=bulk status=private"
It seems that library recognize that missed volume:
LIBNEO4000 000456L3 Private SHITSM01 132
But I am not sure that data on this volume can be get back, any comment?
Thank you!
From: William ZHANG
Sent: Thursday, June 10, 2010 9:26 AM
To: 'ADSM-L AT VM.MARIST DOT EDU'
Subject: volume missed in library
Hello All,
I made mistake:
My tape library overland neo4000 occurs a HW fail when move volume media.
And then I take this volume out of tape library (want to put it again) and run
command "audit library LIBNEO4000 checklabel=barcode"
Then , that missed volume disappeared from tape library using "query libvol" ,
I think there are important data in that volume.
So how can I put that volume into tape library again and do not make data
missed ? or can I do " audit volume vol_name fix=yes" to let TSM backup
missed data again?
If there are archived data, is there any way to get them back?
Warm regards,
william
|
