[ADSM-L] how to view the content of a database (db)
2009-05-05 18:07:05
Hi Everyone,
I have a database file 12Gb in size and it's stored on the hard disk as
devclass file. I want to have a look at it's content but the command "q
content volumename" doesn't work. Is there a command that shows the
content of a database? Please help!
P.S. I search the archive but couldn't fine any references to database.
Thank you.
Desalegne Guangul
Regional Occupational Health
1800 Harrison St. 21st Floor
510-625-3038 or tieline 8/428-3038
NOTICE TO RECIPIENT: If you are not the intended recipient of this
e-mail, you are prohibited from sharing, copying, or otherwise using or
disclosing its contents. If you have received this e-mail in error,
please notify the sender immediately by reply e-mail and permanently
delete this e-mail and any attachments without reading, forwarding or
saving them. Thank you.
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [ADSM-L] how to view the content of a database (db),
Desalegne Guangul <=
|
|
|