Re: [ADSM-L] Labelling mass volume of tapes with Label Libvol
2008-11-13 10:48:51
If your TSM server runs Windows, go to the Setup Wizard under Label
Media. Using the wizard there will only label one tape at a time, but it
will make use of all the tape drives at once, rather than one at a time.
That's a much faster process.
--
Mark Stapleton (mark.stapleton AT cdw DOT com)
CDW Berbee
System engineer
7145 Boone Avenue North, Suite 140
Brooklyn Park MN 55428-1511
763-592-5963
www.berbee.com
> -----Original Message-----
> From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf
> Of Andrew Collyer
> Sent: Thursday, November 13, 2008 10:36 AM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: [ADSM-L] Labelling mass volume of tapes with Label Libvol
>
> Hi,
>
> I have a new TS3500 library with 2500 scratch tapes. I'm running a
> LABEL
> LIBVOL command within TSM 5.5.1.1 but unfortunately it is labelling
one
> tape at a time. I'm using the barcode as the source.
>
> Is there a way to label more than one tape at a time? It's a good
> waste of
> time and plenty of drives!
>
> Thanks.
>
> Andrew
>
> -----------------------------------------
> Find out about our efforts to create gardens in Yorkshire's primary
> schools using a million green fingers by following this link:
> http://greenfingers.yorkshirewater.com/
>
> The information in this e-mail is confidential and may also be
> legally privileged. The contents are intended for recipient only
> and are subject to the legal notice available at
> http://www.keldagroup.com/email.htm Yorkshire Water Services
> Limited
> Registered Office Western House Halifax Road Bradford BD6 2SZ
> Registered in England and Wales No 2366682
|
|
|