ADSM-L

Re: [ADSM-L] CHECKIN problom

2008-05-21 09:40:25
Subject: Re: [ADSM-L] CHECKIN problom
From: Jeff White <Jeff.White AT WOOLWORTHS.CO DOT UK>
To: ADSM-L AT VM.MARIST DOT EDU
Date: Wed, 21 May 2008 14:38:33 +0100
Jane

Yes, looks like the element addresses are ok. The TS3500 library itself
has an inventory option which can be run from the operator panel. This
scanned all of the tapes etc. That looked ok. It all looks consistent,
but it's just the CHECKIN causing me the problem

-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Baker, Jane
Sent: 21 May 2008 14:31
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: [ADSM-L] CHECKIN problom

I don't have knowledge of the TS3500's but do have logical library
partitioning, have you tried comparing the element addresses as shown in
a 'q libvol' to the web interface ones, you said you performed an
'inventory' is this in the form of an 'audit libr command at TSM level'
which should eliminate consistencies between the library hardware & the
TSM inventory?

Just a thought, might be worth checking what the library thinks is where
from the hardware side, vs TSM's view of it all...

HTH.
Jane. 


 
Jane Baker
AIX Technical Specialist
AIX/BASIS TEAM


-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Jeff White
Sent: 21 May 2008 14:19
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] CHECKIN problom

Hi

 

TSM Server v5.4.0.0

TS3500 tape library, SCSI attached

LTO3 tapes

 

Hi

 

I have a problem running the CHECKIN command.

 

My TS3500 tape library has approx 700 slots across two frames. A number
of tapes have been returned because at last i have managed to get
approval to expire data more aggressively than previously.

 

So, i load in approx 120 tapes into the entry port and i can see all of
the tapes are loaded into slots in the library. Frame A is full and
Frame B is now being used. From the library display, i can see all of
those tapes in IMPORT status. 

 

>From the library web display, my TSM logical library has  a max carts
value of 400 of which 229 are used.

 

When i run 'CHECKIN LIBVOL lib-name SEARCH=YES STATUS=SCRATCH CHECKL=B'
i got 36 tapes loaded and then received the following message:

 

ANR8382W Library CO3500 is now full

 

Subsequent CHECKIN commands simply show the ANR8382W message above. 

 

I know the tapes are in there and the library display shows them. I have
performed a library inventory (from the TS3500) but this has had no
effect.

 

A 'Q LIBR libr F=D' command does'nt show anything that indicated a limit
on the number of tapes it can have in the library.

 

Any thoughts appreciated

 

Jeff White


************************************************************************
****
Woolworths plc
Registered Office: 242 Marylebone Road, London NW1 6JL 
Registered in England, Number 104206

This e-mail is only intended for the person(s) to whom it is addressed
and 
may contain confidential information.  Unless stated to the contrary,
any 
opinions or comments are personal to the writer and do not represent the

official view of the company.  If you have received this e-mail in
error, 
please notify us immediately by reply e-mail and then delete this
message 
from your system Please do not copy it or use it for any purposes,  or 
disclose its contents to any other person.  Thank you for your
co-operation.
************************************************************************
****
------------------------------------------------------------------------
------------
Email scanned for viruses and unwanted content by emailsystems

Information regarding this service can be found at www.emailsystems.com


Please check that this email is addressed to you. If not, you should
delete it immediately as its contents may be confidential and its
disclosure, copying or distribution unlawful.

C. & J. Clark International Limited takes steps to prevent the
transmission of electronic viruses but responsibility for screening
incoming messages and the risk of such transmission lies with the
recipient.

C. & J. Clark International Limited Trading as Clarks Registered in
England number 141015.
Registered office 40 High Street, Street, Somerset. BA16 0EQ. England.

This message has been scanned for viruses by BlackSpider MailControl -
www.blackspider.com
------------------------------------------------------------------------
--------------
Email scanned for viruses and spam by the Woolworths
anti-virus systems.

If you believe this email is spam, please forward to
suspectspam AT woolworths.co DOT uk
****************************************************************************
Woolworths plc
Registered Office: 242 Marylebone Road, London NW1 6JL 
Registered in England, Number 104206

This e-mail is only intended for the person(s) to whom it is addressed and 
may contain confidential information.  Unless stated to the contrary, any 
opinions or comments are personal to the writer and do not represent the 
official view of the company.  If you have received this e-mail in error, 
please notify us immediately by reply e-mail and then delete this message 
from your system Please do not copy it or use it for any purposes,  or 
disclose its contents to any other person.  Thank you for your co-operation.
****************************************************************************
------------------------------------------------------------------------------------
Email scanned for viruses and unwanted content by emailsystems

Information regarding this service can be found at www.emailsystems.com
<Prev in Thread] Current Thread [Next in Thread>