Re: [ADSM-L] How to reclaim "FILLING" volumes
2007-10-09 17:47:19
>>> nick.laflamme AT NIST DOT GOV 10/9/2007 2:40 PM >>>
Nicholas Rodolfich wrote:
> I have TSM server 5.3.5 on AIX 5.3.5 with an IBM 3584 library with
16
> drives. In my offsite pool I have approximately 300 volumes with
very
> low utilization but they are in the FILLING state, I would expect
them
> to be in the FULL, EMPTY or PENDING state. Is there a way to target
> these volumes with reclamation? I suppose I could do a move data on
all
> of them?
>
They certainly should be reclaimable even if they're in FILLING state
if
they're off-site.
Did you use a command like MOVE DRMEDIA so TSM knows they're off-site?
>>Yes, I validated that the volumes in question are access=offsite
What happens if you try a manual RECLAIM STGPOOL against that storage
pool?
>>I started a manual earlier and it is running now
Does it say it finished normally without writing any fresh new
tapes?
>> Not sure
Do your reclamations work for that storage pool for FULL tapes
that are off-site?
>>Yes
Sorry to have more questions than answers,
Nick
IMPORTANT NOTICE: This message and any included attachments are from East
Jefferson General Hospital, and is intended only for the addressee(s), and may
include Protected Health (PHI) or other confidential information. If you are
the intended recipient, you are obligated to maintain it in a secure and
confidential manner and re-disclosure without additional consent or as
permitted by law is prohibited. If you are not the intended recipient, use of
this information is strictly prohibited and may be unlawful. Please promptly
reply to the sender by email and delete this message from your computer. East
Jefferson General Hospital greatly appreciates your cooperation.
|
|
|