I'm no expert in networking, but  I do know that you have to be careful
with multiple
interfaces in that that they may not work as you expect.

For example . . . are the client nodes on the same network as the TSM
server?  By
"network", I mean the network part of the ip address.  If they are not (ie:
their
traffic gets to TSM via a router), then you can get inbound traffic to the
TSM server
arriving on one nic and outbound traffic from the TSM server on the nic
assigned
to the default route.

Rick

"ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> wrote on 06/26/2007
06:14:32 PM:

> AFAIK yes ... just point your TCPSERVERADDRESS to working IP address,
> it should work /me thinks ...
>
> On 6/26/07, Daad Ali <daad_l AT yahoo DOT ca> wrote:
> > Hi ALL,
> >
> >   I have a server that has two interfaces configured (Two IP addresses
as well).
> >
> >   Without using EtherChannel or any redunancy like that, is there a way
to tell the client to use the 2nd interface incase the first one fails.
> >


-----------------------------------------
The information contained in this message is intended only for the
personal and confidential use of the recipient(s) named above. If
the reader of this message is not the intended recipient or an
agent responsible for delivering it to the intended recipient, you
are hereby notified that you have received this document in error
and that any review, dissemination, distribution, or copying of
this message is strictly prohibited. If you have received this
communication in error, please notify us immediately, and delete
the original message.