Re: change in reusedelay value and time it take for tapes to change status
2007-02-21 17:58:55
Barbara
AFAIK, there are some of these sort of checks that are done once per
hour, and this is relative to the last start time of the server.
There is nothing you can do to speed it up short of a server restart. I
don't know where I heard this, its just in the back of my conciousness
somewhere.
Regards
Steve
Steve Harris
AIX and TSM Admin
Brisbane Australia
Barbara Andrews wrote:
Thanks, but I already know how to change the reusedelay value, and I don't
want to set the value to 0. I'm wondering if there is another setting
that tells TSM how often to check and see what the reusedelay value is set
to.
Subject:
Re: change in reusedelay value and time it take for tapes to change status
From:
"Hudalla, Bill" <Bill.Hudalla AT CHSINC DOT COM>
To:
ADSM-L AT VM.MARIST DOT EDU
Date:
Wed, 21 Feb 2007 15:26:14 -0600
How about "upd stg (stgpoolname) reuse=0"
Bill
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On
Behalf Of
Barbara Andrews
Sent: Wednesday, February 21, 2007 2:53 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] change in reusedelay value and time it take for tapes
to change status
When I set the reusedelay period for one of my tape storage pools to a
lower value in order to force more tapes to go from pending status to
empty, I notice that it can take anywhere from a few minutes to as much
as
an hour for the tapes to change status. I'm guessing this is because
there is some interval set at which TSM checks on the resusedelay value.
Does anybody know how/if this value can be changed so that I can make
the
interval shorter?
Barbara Andrews, Systems Software Specialist
++++++++++++++++++++++++++++++++++++++++
Western New York Regional Information Center
(716)821-7130
bandrews AT e1b DOT org
|
|
|