Tape-Volume status: pending & empty
2006-08-07 08:16:42
Hi TSM'ers,
I'm doing a lengthy process of moving data from primary tape stg-pool A
to another primary tape stg-pool B by having set
upda stgp A access=readonly
upda stgp A reclaimstgp=B
upda stgp A reclaim=0
This setting caused that lengthy "Reclamation Precess".
Most of the tapes having belonged to A ended in "Pending" and
after "delay-period"-days went to "Scratch" (as usual behavior).
But quite a lot of tapes from A have now a volume status of "Empty" and
still belong to A.
Questions:
1. What's the reason for not having ended in "Pending" ?
2. I'd like to run a sequence of
"del vol <volid>"
Any objections ?
Regards, Peter
--
MfG / Ciao - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Peter Dümpert Email: p.duempert AT tu-bs DOT
de
Rechenzentrum der Technischen Universität Fax : ++49/531/391-5549
D 38092 Braunschweig Tel : ++49/531/391-5535
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Tape-Volume status: pending & empty,
Peter Duempert <=
|
|
|