How about defining a new pol, as the reclaim stgpool for the pool you sish to 
copy.
Then, just set reclamation on your copy pool to zero, and let her rip.
 


Gary Lee
Senior System Programmer
Ball State University
 
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of 
Nast, Jeff P.
Sent: Tuesday, December 06, 2005 9:15 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Copying a COPYPOOL...

Hello all,

We recently purchased IBM 3592-J1A tape drives and are in the process of 
converting from 3590-E1A in our 3494 library. The TAPEPOOL migration is going 
well using "move data" command. But we are stuck on how to migrate our
COPYPOOL01 (3590-E1A) to COPYPOOL02 (3592-J1A). There is the ugly option to 
"destroy" the 3590 tapes, but I would consider that a last resort, unless it's 
the only resort...

Any suggestions? Thank you in advance!

-Jeff Nast
Senior Systems Engineer
SMDC (St. Mary's / Duluth Clinic)
http://www.smdc.org/




This e-mail communication and any attachments may contain confidential and 
privileged information for the use of the designated recipients named above. If 
you are not the intended recipient, you are hereby notified that you have 
received this communication in error and that any review, disclosure, 
dissemination, distribution or copying of it or its contents is prohibited. As 
required by federal and state laws, you need to hold this information as 
privileged and confidential. If you have received this communication in error, 
please notify the sender and destroy all copies of this communication and any 
attachments. 

 

--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.362 / Virus Database: 267.13.12/192 - Release Date: 12/5/2005
 

-- 
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.362 / Virus Database: 267.13.12/192 - Release Date: 12/5/2005