Re: BACKUP STG COMMAND
2005-11-01 12:47:05
Milton,
You move data solution will not work. TSM does not allow you to move
data from one copy pool to another. You can move data between primary
pools but copy pools are not allowed.
--
Regards,
Mark D. Rodriguez
President MDR Consulting, Inc.
===============================================================================
MDR Consulting
The very best in Technical Training and Consulting.
IBM Advanced Business Partner
SAIR Linux and GNU Authorized Center for Education
IBM Certified Advanced Technical Expert, CATE
AIX Support and Performance Tuning, RS6000 SP, TSM/ADSM and Linux
Red Hat Certified Engineer, RHCE
===============================================================================
Johnson, Milton wrote:
You could:
1) Create 2 offsite copypools (say OFF1 and OFF2)
2) Day 1 - for each volume in OFF1
do
move data volume stg=oFF2 reconstruct=yes
done
backup stg primarypool OFF2
Bring back all OFF1 volume that are offsite
3) Day 2 - for each volume in OFF2
do
move data volume stg=oFF1 reconstruct=yes
done
backup stg primarypool OFF1
Bring back all OFF1 volume that are offsite
4) Day 3 - go to step 2
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Aaron Becar
Sent: Monday, October 31, 2005 1:16 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: BACKUP STG COMMAND
Hey!
In an effort to minimize the number of tapes that go off site, is there
an option that I can add to the backup stg command to copy everything in
the primary pool to the copy pool, and resets the previous copy, and
creates a new copy?
Thanks!
|
|
|