I think you have to create a deviceCLASS called LTO (or something) and set
the recording format to drive.
Then when tsm mounts a tape the drive will recognize what kind of tape
(lto1 or lto2) and use the correct format. If you want compression you
will need to turn that on on the drive it self, this would be done with
tapeutil I pressume.

This would be the only way to use mixed media in the scratch pool.

If you want to separate the different media to different storagepools
you need to create two device classes (lto1 and lto2) and use the define
vol  command to assign the volumes to the storage pools as you like it.

regards

Rushforth, Tim wrote:

Hi:



We are looking at upgrading one of our 3584 libraries to all LTO2 drives
(we currently have a mix of LTO1 and LTO2 drives) and use a mixture of
LTO1 and LTO2 media (we currently only use LTO1 media).



The admin guide states:



Mixed Media and Storage Pools:

You cannot mix media formats in a storage pool. This includes LTO1 and
LTO2 formats. Each unique media format must be mapped to a separate
storage pool through its own device class.



We want to continue using LTO1 media (reading and writing) and also use
LTO2 media (using the full capacity) - all with LTO2 drives.



So I think one way of doing this is to setup a device class specifying
ULTRIUMC and another with ULTRIUM2C and then point stgpools with the
appropriate device class.



If this is done, can scratch tapes be used for both stgpools?

Will TSM just use LTO1 media for the ULTRIUMC stgpool and only use LTO2
media with the ULTRIUM2C stgpool?

If there were no LTO1 media, would TSM use LTO2 media for the ULTRIUMC
stgpool (writing in LTO1 format)?



Thanks,



Tim Rushforth

City of Winnipeg

--
Otto Schakenbos
System Administrator

TEL: +49-7151/502 8468
FAX: +49-7151/502 8489
MOBILE: +49-172/7102715
E-MAIL: oschakenbos AT teleflex DOT com

Corporate IT Europe
Teleflex Holding GmbH
Fronackerstrasse 33-35
71332 Waiblingen
GERMANY