Did you run an incremental backup after the image backup?

If you look up the BACKUP IMAGE command in the client manual, you will see
a discussion about using image backup along with incremental backups to do
what you want. Check out method 1.

Regards,

Andy

Andy Raibeck
IBM Software Group
Tivoli Storage Manager Client Development
Internal Notes e-mail: Andrew Raibeck/Tucson/IBM@IBMUS
Internet e-mail: storman AT us.ibm DOT com

The only dumb question is the one that goes unasked.
The command line is your friend.
"Good enough" is the enemy of excellence.

"ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> wrote on 2005-01-24
13:17:28:

> Hi all
>
> I'm trying to restore an image of one of my Windows 2000 server
>
> Everything goes well except that the files or folders that have been
> deleted after the image are there ... and I dont want them. ..
>
> I did the command :
>
> dsmc retore image \\server\c$ c: -asrmode=yes -noprompt -incremental
> -deletefiles -virtualnode=server
>
> I'm using the procedure "TSM recovery technique using Windows
> pre-installation environment
>
> I looked into the documentation ... they are talking about "this
procedure
> assumes that your backup followed the correct procedure to allow for
> incremental image restore using the -DELETEFILES option ....
> What correct procedure ???????
>
> any ideas ?????
>
> thanks
>
> Luc Beaudoin
> Network Administrator / TSM / SAN
> Hopital General Juif S.M.B.D.
> Tel: (514) 340-8222 ext:8254