I use the following in a shell script:

dsmadmc -id=$ID -pass=$PASS -dataonly=yes "select nodename,message from
actlog where date_time>= '$DATE 22:00' and msgno=4961 order by nodename"

This reports on all data transfers from the previous evening. It could
be piped through a grep for particular clients.

Thanks,

Sam 

-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Ray Louvier
Sent: 28 April 2004 12:21
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Select Commands

Does anyone know a select command to pull out how much data was backed
for an individual Node for that night. Yea I know you look at logs and
find it but it would be much easier to setup a command to pull certain
nodes to track just those. 

Ray


-----------------------------------------------------------------
ATTENTION:
The information in this electronic mail message is private and
confidential, and only intended for the addressee. Should you
receive this message by mistake, you are hereby notified that
any disclosure, reproduction, distribution or use of this
message is strictly prohibited. Please inform the sender by
reply transmission and delete the message without copying or
opening it.

Messages and attachments are scanned for all viruses known.
If this message contains password-protected attachments, the
files have NOT been scanned for viruses by the ING mail domain.
Always scan attachments before opening them.
-----------------------------------------------------------------