I just set up our two new LTO2-drives in an 3584-expantion frame. We
previously had the base-frame and four LTO1 drives. What I did was:

        o connect hardware
        o run cfgmgr
        o define drives (DEFINE DRIVE 3584LTO TAPE4)
        o define paths  (DEFINE PATH TSM TAPE4 SRCTYPE=SERVER \
                         DESTTYPE=DRIVE LIBRARY=3584LTO DEVICE=/dev/rmt4)
        o define devclass (DEFINE DEVCLASS 3584LTO2 DEVTYPE=LTO \
                           FORMAT=ultrium2c MOUNTLIMIT=DRIVES \
                           MOUNTWAIT=60 MOUNTRETENTION=60 PREFIX=ADSM 
LIBRARY=3584LTO
        o define new storage pool to use this devclass

        o label new tapes, LABELSource=barcode
        o check them in

And it works! Anybody see anything else I should have done?


   -jf