Re: Use mtlib or mt to mount a tape in 3494
2003-08-18 13:40:15
/usr/bin/mtlib -l/dev/$LMCP -f/dev/$RMT -m -V$VOLSER
where $LMCP is your library, $RMT is the drive you wish to use and $VOLSER
is your tape volser...
so to mount volume ABC123 on drive rmt1 in atl lcmp1 use
mtlib -l/dev/lmcp1 -f/dev/rmt1 -m -VABC123
then -d is dismount...
it is always nice to check in TSM to see if a drive is or isn't in use
first... (if already in use, your command just fails...)
YOU have to make sure the volser is proper... this will let you mount any
volume no matter what the category is!!!!!!
at least this works here....
Mike Cantrell
<Mike_Cantrell@SA To: ADSM-L AT VM.MARIST
DOT EDU
KSINC.COM> cc:
Sent by: "ADSM: Subject: Use mtlib or mt to
mount a tape in 3494
Dist Stor
Manager"
<[email protected]
.EDU>
08/18/2003 12:13
PM
Please respond to
"ADSM: Dist Stor
Manager"
Hello
We are using TSM 5.1 with an IBM 3494 library and I would like to use the
mtlib or mt command to mount a tape in our 3500 drive and do a dd or tar.
Any ideas?
Thanks
Mike
|
|
|