Re: difference in q node f=d output
2003-04-03 10:01:24
Look up the -displaymode option in the Admin Reference, in the chapter on
using the Admin command line interface.
Regards,
Andy
Andy Raibeck
IBM Software Group
Tivoli Storage Manager Client Development
Internal Notes e-mail: Andrew Raibeck/Tucson/IBM@IBMUS
Internet e-mail: storman AT us.eyebm DOT com (change eye to i to reply)
The only dumb question is the one that goes unasked.
The command line is your friend.
"Good enough" is the enemy of excellence.
"Lee, Gary D." <GLEE AT BSU DOT EDU>
Sent by: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
04/03/2003 07:48
Please respond to "ADSM: Dist Stor Manager"
To: ADSM-L AT VM.MARIST DOT EDU
cc:
Subject: difference in q node f=d output
Working on a script to look at all my tsm nodes.
In the command-line admin client, q node * f=d produces a more lenier
vertical listing.
However, when run from a shell script, a very tabular listing is produced.
Is there anyw way to get the vertical lysting to be produced?
Still lookin gin the manuals, but no success yet.
Gary Lee
Senior Operating Systems Analyst
Ball State University
phone 765-285-1310
|
|
|