Actually on a Novell Cluster, Cluster node should =no. Here is an
instruction sheet I created while I was setting up my clustered nodes. It
works very well.

Dave Marsh
LAN Engineer
Scottsdale Healthcare, Network Services
dmarsh AT shc DOT org

-----Original Message-----
From: Odd-Magne Sekkingstad [mailto:oddmagne AT BLUEYONDER.CO DOT UK]
Sent: Monday, March 17, 2003 1:14 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Netware6 Cluster problem


Hi,

I have a Netware6 cluster where I can't get the TSM client (v5.1.5.15) to
work properly.
I have manage to set up a client to backup the non clustered disk (SYS:),
but when I try to configuered the backup of clustered volumes I run into
some strange problems.

The option file is located at cd1shr1:/tsm/dsm.opt with the following
changes from the default dsm.opt that is used for backing up SYS:
    clusternode yes
    nodename hwcd1shr1p
    httpport 1582
    domain cd1shr1:
    nwpwfile yes
    passworddir cd1shr1:/tsm
    schedlogname cd1shr1:/tsm/log/dsmsched.log
    errorlogname cd1shr1:/tsm/log/dsmerror.log

When I load the client with "dsmc q sched -optfile=cd1shr1:/tsm/dsm.opt" I
get the following error message:

ANS1036S Invalid option '' found in option file '' at line : 0
Invalid entry ''

This error message is logged in cd1shr1:/tsm/log/dsmerror.log, so at least
the client is reading the option file.

If I remove the line 'clusternode yes' from the option file the client
works fine, except you have to retype the password everytime the cluster
failsover.

Do anybody have an idea what is wrong, and how to fix it?
(Will call Tivoli support tomorrow, since it past office hour today)
--
Regards,
Odd-Magne

Procedure for setting TSM on a NetWare Cluster.doc
Description: MS-Word document