I believe the Process should be completed with Failure status , if the
mount request was cancelled or timed out.

( i thinks its TSM internal.May be Raibeck can answer this better )

Regds

raghu.



                    Richard Foster
                    <Richard.Foster@        To:     ADSM-L AT VM.MARIST DOT EDU
                    HYDRO.COM>              cc:
                    Sent by: "ADSM:         Subject:     Re: timeout value for 
processes
                    Dist Stor
                    Manager"
                    <[email protected]
                    T.EDU>


                    12/18/2002 04:20
                    PM
                    Please respond
                    to "ADSM: Dist
                    Stor Manager"





The Mountwait parameter only specifies how long the process will wait for a
tape to be mounted after the process has been allocated the necessary
drive(s).

If I understand Henrik's question, there doesn't appear to be a parameter
which governs how long a process will wait for the tape drives to become
available.

We just run a script which cancels all Reclaim processes, whether they are
active, waiting for tape mounts or waiting for drives.

Richard Foster
Norsk Hydro

----------------------------
mountwait parameter in devclass definition

regds
Raghu

----------------------------
Hi all!

Is there a server option or a another why to specify for how long a process
will be active?

Example, If all drives are busy I might not want reclamation to be pending
for hours until two drive becomes available.

Henrik.Wahlstedt