Hi,
I believe I have an answer for question 3. But, USE WITH CAUTION - I have
not really tried it myself, but when I have done an upgrade from v.3.7 to
4.x or 5.x, I've used a cmd called tsmfixup.cmd. In that file you can find
the commands for initializing a server, with a short description of the
commands. I recommend you take a look at this file, and test it on a
non-critical server.
rgds
Geirr G. Halvorsen
-----Original Message-----
From: Rosa Leung [mailto:rosal AT CA.IBM DOT COM]
Sent: 16. september 2002 20:19
To: ADSM-L AT VM.MARIST DOT EDU
Subject: TSM 5.1.0.0 installation questions
Hi,
I am trying to install TSM 5.1.0.0 to about 6-9 NT and Win2000 servers
for a client, Each server has single tape device, there is no ATL, I have
done about 5, and I run into few problems, they are
1. during the TSM server configuration, just before TSM server
initialization, I often got FM - code error pop out screen.
2. the above error, does not really will stop the TSM server
initialization, but there were 2 servers that have DB2 running, got time
out during the TSM server initialization.
3. If I do not using the wizard to initialize TSM server, what are the
manual steps I can initialize the server, does this document any Doc.?
4. I have done de-installed once, does this de-install corrupt registry?
Thanks.
Rosa Leung
|