Mountwait on the device class of the pool.

Kelly J. Lipp
Storage Solutions Specialists, Inc.
PO Box 51313
Colorado Springs, CO 80949
lipp AT storsol DOT com or kelly.lipp AT storserver DOT com
www.storsol.com or www.storserver.com
(719)531-5926
Fax: (240)539-7175


-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU]On Behalf Of
Burak Demircan
Sent: Wednesday, August 21, 2002 6:05 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: ANS1312E Server media mount not possible


the high and low tresholds of any stg pool determines when the data is moved
to
the next
pool.
see below options are from my disk pool which goes to a tape pool when it is
90
% full until it is 50 % full

High Mig Pct: 90  >>>>>>this is the percent where your data starts to go
next
pool
Low Mig Pct: 50   >>>>>>until this percent
NExt Storage Pool >>>>> The pool where data goes in these limits



tsm: TSM01.MBT>q stg backuppool

Storage      Device       Estimated    Pct    Pct  High  Low  Next Stora-
Pool Name    Class Name    Capacity   Util   Migr   Mig  Mig  ge Pool
                               (MB)                 Pct  Pct
-----------  ----------  ----------  -----  -----  ----  ---  -----------
BACKUPPOOL   DISK          26 000.0    0.0    0.0     90   50  3583POOL








        deehre01 AT LOUISVILLE DOT EDU
        Sent by: ADSM-L AT VM.MARIST DOT EDU

        21.08.2002 15:47
        Please respond to ADSM-L

                        To:        ADSM-L AT VM.MARIST DOT EDU
                        cc:
                        Subject:        Re: ANS1312E Server media mount not
possible

>think this also:
>this volume may be full and next storage which is most probably a
tapepool
>need
>a mount point?

Which parameter controls how long a backup session will wait for a
mount of a secondary storage pool volume after the primary storage pool
fills?