I have successfully managed to run a command sequence (via an Admin Client
GUI) using the form
-preschedulecmd='pathname1' -postschedulecmd='pathname2'
, but when testing a "nowait" variant using the form
-presNchedulecmd='pathname1' -postNschedulecmd='pathname2'
, the client scheduler aborted. I used the above forms as recommended in a
posting on adsm.org.
What have I done wrongly? Our TSM level is 4.2.
Thanks for any help,
Rupert Wood
Technical Specialist
Strategic Outsourcing
IBM (NZ) Ltd.
Telephone: (+64 4) 576-9782 extn. 9782
Fax: (+64 4) 576-5808
e-mail: ruwood AT nz1.ibm DOT com
---------------------------------------------------------------------
The contents of this e-mail are confidential.
If you have received this communication by mistake,
please advise the sender immediately and delete the message and
any attachments.
The views expressed in this e-mail are not necessarily the views of
Westpac Banking Corporation.
Westpac Banking Corporation is incorporated in New South Wales, Australia.
---------------------------------------------------------------------
|