I believe your "move data" is the easiest and simplest way.

David Longo

>>> kleinr AT EXCHANGE.NIH DOT GOV 07/31/02 03:18PM >>>
Yesterday, I accidently changed the maxcapcity parameter for my main tape
device class to 22 mb instead of 22 GB.  As a consequence, our TSM server (v
4.2 on OS/390) has used up most of our tapes.  I have corrected the
parameter, but that does not help with the tapes written to while the 22 mb
value was in effect.  Is there any easy way to tell TSM that the tapes it
thinks are full with only 22 mb really have plenty of room left?  So far, I
have been using the move data command to empty out these tapes, but that is
only does one at a time.  I tried using migration, but migration appears to
be based on percent utilization, not on  amount of data.  Has anyone ever
made this mistake and found an easy way to rectify it?

Thanks for any suggestions.



"MMS <health-first.org>" made the following
 annotations on 08/02/2002 04:24:28 PM
------------------------------------------------------------------------------
This message is for the named person's use only.  It may contain confidential, 
proprietary, or legally privileged information.  No confidentiality or 
privilege is waived or lost by any mistransmission.  If you receive this 
message in error, please immediately delete it and all copies of it from your 
system, destroy any hard copies of it, and notify the sender.  You must not, 
directly or indirectly, use, disclose, distribute, print, or copy any part of 
this message if you are not the intended recipient.  Health First reserves the 
right to monitor all e-mail communications through its networks.  Any views or 
opinions expressed in this message are solely those of the individual sender, 
except (1) where the message states such views or opinions are on behalf of a 
particular entity;  and (2) the sender is authorized by the entity to give such 
views or opinions.

==============================================================================