Microsoft cluster server / TSM
2002-05-14 09:37:18
Need a little help. I'm about to set up a TSM for Microsoft cluster server.
It will be an active/active configuration. I plan on doing it as follows:
Machinge A
Physical disk H is a cluster group
Machine B
Physical disk I is a cluster group
Physical disk Q (quorum) is a cluster group
Machine A (normally owns disk H)
install local scheduler... always running
install scheduler for cluster group H (pointing to a dsm.opt file on the H
drive)... always running
install scheduler for cluster group Q (pointing to a dsm.opt file on the Q
drive)... always running
install failover scheduler pointing to the dsm.opt file on the I: drive which
will manage cluster group I: in the event of failure (this will be a "Generic
Service Resource for Failover" this
scheduler is not on auto start=yes)
Machine B (normally owns disk I:)
install local scheduler... always running
install scheduler for cluster group I (pointing to a dsm.opt file on the I
drive)... always running
install scheduler for cluster group Q (pointing to a dsm.opt file on the Q
drive)... always running
install failover scheduler pointing to the dsm.opt file on the H: drive which
will manage cluster group H:in the event of Machine A failure. (this will be a
"Generic Service Resource for Failover"
this scheduler is not on auto start=yes)
Here are my two questions:
Should the scheduler for Q be running on both machine A and machine B?
For machine A...when I set up "Depencies" in cluster manager for the "Generic
Service Resource for Failover" and it states to "add all physical disk
resources", do I add both H and I?
I can't seem to get a straight answer on this one.
Regards, Joe
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Microsoft cluster server / TSM,
Wholey, Joseph (TGA\MLOL) <=
|
|
|