Thanks for your reply's.
 But the proper atape and atldd drivers were installed of course.
 Using the mtlib command showed the desired response.

        After the manual libtype restore, the system operated like it used
to. This indicated that the drivers were functioning OK.

To be complete i put a clipping here from the message guide. This was the
message we got during the db restore.
        ANR8476E Operation is not supported for the libtype of library
library name.
        Explanation: The operation failed because the libtype of the library
is not supported for the operation.
        System Action: The operation fails.
        User Response: Use a different libtype such as MANUAL to perform the
operation.

Any suggestions?



Re: TSM Restore Using 349X lib fails.
 Forum:   ADSM.ORG - ADSM / TSM Mailing List Archive
 Date:      Feb 04, 10:26
 From:      Davidson, Becky <Becky.Davidson AT SLBG DOT COM>

Did you install atape and atldd?  Before using tsm make sure that mtlib can
talk to it.  You can test that by simply doing an mtlib -l/dev/lmcp0 -qL
This will tell you if the machine can talk to the tape library.  If it can't
make sure that you can ping it and that the /etc/ibmatl.conf is configured
properly.
Good luck
Becky