Re: Tape Drive Failures
2015-10-04 17:13:40
Here is a look at what the message is giving me in the actlog when it fails.
It looks just like a plan tape error:
ANR8499I Command accepted.
01/05/02 08:58:03 ANR8300E I/O error on library MAGSTAR (OP=00006C03,
CC=314, KEY=05, ASC=3B, ASCQ=0E,
SENSE=70.00.05.00.00.0-
0.00.48.00.00.00.00.3B.0E.FF.02.00.A8.00.00.1E.09.01.00-
.00.00.00.00.00.00.A5.00.00.00.00.00.00.00.00.00.00.00.-
00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.0-
0.00.00.00.00.00.00.00.00.00.00.00.32.38.37.20.20.20.20-
.00., Description=The source slot or drive was empty
in
an attempt to move a volume). Refer to Appendix B in
the
'Messages' manual for recommended action.
01/05/02 08:58:03 ANR9999D mmsscsi.c(10695): Could not move volume 1DA7D
from slot 31 to slot 16.
01/05/02 08:58:03 ANR8841I Remove volume from slot 31 of library MAGSTAR
at
your convenience.
After this the drive then goes offline. So when the archive runs at 22:30
this is the message it gets:
01/05/02 22:41:20 ANR8447E No drives are currently available in library
MAGSTAR.
01/05/02 22:41:21 ANR1404W Scratch volume mount request denied - mount
failed.
When i look at the error message in the O/S errpt this is what i see
4865FA9B 0108012102 P H rmt1 TAPE OPERATION ERROR
476B351D 0108012102 P H rmt1 TAPE DRIVE FAILURE
0F78A011 0108011902 T H rmt1 RECOVERY LOGIC INITIATED BY DEVICE
Any ideas???
Bill Wheeler
PDM Administrator
La-Z-Boy Incorporated
(734) 242-1444 x 6170
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- Tape Drive Failures, Bill Wheeler
- Re: Tape Drive Failures, Juan Manuel Lspez
- Re: Tape Drive Failures, Braich, Raminder
- Re: Tape Drive Failures, George Lesho
- Re: Tape Drive Failures, Bill Wheeler
- Re: Tape Drive Failures, Tab Trepagnier
- Re: Tape Drive Failures, PINNI, BALANAND (SBCSI)
- Re: Tape Drive Failures, Robin Sharpe
- Re: Tape Drive Failures, George Lesho [mailto:GLesho
- Re: Tape Drive Failures,
Bill Wheeler [mailto:Bill.Wheeler <=
|
|
|