Re: backup/restore question
2001-08-30 15:14:19
Paul,
Our NT admins did just that by doing an archive followed by a retrieve.
They were moving to a new machine. You could also do it with backups,
probably several ways... here are two off the top of my head:
1. Change the backup copy group to "MODE=ABSOLUTE". Do your backup. Mode
absolute will cause all data to be backed up again, changed or not, so it
should all go on one tape. I did this for a disaster recovery test once.
Don't forget to change back to MODE=MODIFIED when you're done.
2. Register a new node, if you have anavailable license. Now run your
backup using "-virtualnodename={the new node}". Do your restore with the
same -virtualnodename parameter. When you're all done, delete the
filespace and the node.
HTH
Robin Sharpe
Berlex Laboratories
"Coviello,
Paul"
<PCoviello@CM To: ADSM-L AT VM.MARIST DOT EDU
C-NH.ORG> cc: (bcc: Robin Sharpe/WA/USR/SHG)
Subject:
08/28/01 backup/restore question
01:36 PM
Please
respond to
"ADSM: Dist
Stor Manager"
Hi,
We need to restore an NT machine, in testing this, it takes approximately
30
hours.
this machine has 27 gb's of data, it is the users X: drive.
is there a way to do a backup to a specific tape and then restore from
there?
we are doing this for growth and replication purposes.
thanks
pc
Paul J Coviello
Sr Systems Analyst
Catholic Medical Center
2456 Brown Ave
Manchester NH 03103
(603) 663-5326
Pcoviello AT cmc-nh DOT org
|
|
|