Re: NT IBM
2001-08-07 21:53:42
Paul,
I have seen some wierdness with the R03 box before, but not on NT. A
couple of thoughts...you say the LP8000's are running in FCAL mode? Why
not fabric?
Also, (this may be obvious) have you got the latest FW for the R03?
-Lloyd
Paul Bestow wrote:
Paul Bestow wrote:
>
> Hello Everybody,
>
> We have a customer with the following set-up:
>
> Clustered Compaq Proliant 6400 Servers (NT4 Enterprise - SP6)
> Emulex LP8000 f-cal HBA's x 2
> Compaq Sanswitch 16 (Brocade 2800)
> IBM SAN Data Gateway 2108 R03
> IBM 3584 Libray with 4 Drives
>
> We are having problems when we try and install the IBM NT Device Drivers
> (1.7.7.6). Sometimes it will install the tape drivers but the not the
> library driver then other times it will only install the library driver and
> not the tape drivers. At one point we did actually get both drivers working
> then we had to reboot the server and it lost all the drivers.
>
> Has anyone had any luck with the above? If so any advice would be greatly
> appreciated.
>
> Thanks in advance
>
> Paul
--
-----------------------------------------------------------------
-----------------------------------------------------------------
Lloyd Dieter - Senior Technology Consultant
Lloyd Dieter - Senior Technology Consultant
Synergy, Inc. http://www.synergyinc.cc ldieter AT snrgy DOT com
Main:716-389-1260 fax:716-389-1267
-----------------------------------------------------------------
=========================================================================
|
|
|