Huh! <and other exclamations of surprise>

I would have sworn I had tried audit vol earlier, but obviously not, because
it worked.

Thanks!

Kai.

>Date:    Mon, 9 Jul 2001 14:47:35 -0600
>From:    Kai Hintze <kai_hintze AT ALBERTSONS DOT COM>
>Subject: Can't reclaim volume using 0 bytes
>
>I have a volume that apparently has 0 bytes used that I can't seem to
>reuse.
>
<snipped list of stuff I tried that didn't work>
>
>I'm down to just checking the tape out of the library and leaving it on
>the
>shelf until the volhist expires. Any other suggestions?
>
>------------------------------
>
>Date:    Mon, 9 Jul 2001 13:55:21 -0700
>From:    "Gill, Geoffrey L." <GEOFFREY.L.GILL AT SAIC DOT COM>
>Subject: Re: Can't reclaim volume using 0 bytes
>
>>07/09/2001 13:15:56  ANR9999D afmigr.c(2619): Reconstruction
>>of aggregates is disabled. Run audit reclaim utilities to
>>re-enable  reconstruction of aggregates.
>
>Kai,
>Check the tape in, make it available and run an audit on it with a
>fix=yes.
>I had the same problem and after I did this it automatically deleted and
>returned to scratch.
>