Group

I have created a script name VOLUME_PCT with the following results:

ANR1461I RUN: Executing command script VOLUME_PCT.
ANR1466I RUN: Command script VOLUME_PCT, Line 5 : select volume_name, 
stgpool_name,pct_utilized from volumes
where upper(stgpool_name)='LNTAPECO' and pct_utilized <50 or 
upper(stgpool_name)='LNTAPENO' and pct_utilized <50
 or upper(stgpool_name)='UNTAPECO' and pct_utilized <50 or 
upper(stgpool_name)='UNTAPENO' and pct_utilized <50
 or upper(stgpool_name)='NTTAPECO' and pct_utilized <50 or 
upper(stgpool_name)='NTTAPENO' and pct_utilized <50.

VOLUME_NAME            STGPOOL_NAME           PCT_UTILIZED
------------------     ------------------                   ------------
A40004                 NTTAPECO                                8.1
A40004                 NTTAPECO                                8.1
A40012                 UNTAPENO                                2.0
A40015                 NTTAPENO                               48.0
A40021                 NTTAPENO                              32.9
A40081                 NTTAPECO                               47.4
A40156                 NTTAPECO                              15.4

ANR1494I RUN: Command return code is 0.
ANR1487I RUN: Command return code is RC_OK (OK).
ANR1462I RUN: Command script VOLUME_PCT completed successfully

My question is how can I generated MOVE DATA commands using the VOLUME_NAMEs in 
the results of the above SCRIPT

Thanks

Joe Marchesani .