Can we have more information like:

type of library? Is it Fibre channel or SCSI. If SCSI what kind of Fibre to
SCSI bridge are you using? What kind of switch are
you using... Brocade..Gadzooks, Mcdata. What management software are you
using to configure the switch? HP Openview, Tivoli....

So many questions!


You need to be sure that the library is seen by the switch in any case.

C

__________________________________________________
Cris Robinson
Backup & Recovery Engineering
Information Technology Support Services
Liberty Mutual Insurance
Portsmouth, New Hampshire
603.431.8400.54837
mailto:cris.robinson AT libertymutual DOT com



> -----Original Message-----
> From: Braich, Raminder [SMTP:raminder.braich AT DAVEY DOT COM]
> Sent: Thursday, August 17, 2000 8:54 AM
> To:   ADSM-L AT VM.MARIST DOT EDU
> Subject:      Re: SAN and Tape Drives
>
> Check the device drivers, the proper ADSM device drivers (ADSMSCSI) have
> to
> be loaded and started in order to make the tape drives visible.
>
> > -----Original Message-----
> > From: Viliam Varga [SMTP:Varga AT LOGIN DOT SK]
> > Sent: Thursday, August 17, 2000 4:06 AM
> > To:   ADSM-L AT VM.MARIST DOT EDU
> > Subject:      SAN and Tape Drives
> >
> > Hi,
> >
> > we want to implement a small SAN (2 TSM servers on Sun Solaris, 1 Disk
> > Array, 1 Tape Library), and we have a problem with HBA QLogic QLA2200.
> > Tape
> > support option on QLA2200 is enabled, but from Solaris I see  only disks
> > and I can't see tape drives.
> > What is wrong? Does anybody have similar problem?
> > Many thanks for any help.
> >
> >
> > Viliam Varga