Re: Invoking DSMC via at command
2000-07-07 15:35:11
Curt, if I remember correctly, I think I copied the dscaeng.txt to the system32
subdirectory.
lisa
"Magura, Curtis" <curtis.magura AT LMCO DOT COM> on 07/07/2000 01:14:35 PM
Please respond to "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
To: ADSM-L AT VM.MARIST DOT EDU
cc: (bcc: Lisa Cabanas/SC/MODOT)
Subject: Invoking DSMC via at command
Trying to issue the command dsmc incr from an at command on NT. It's a long
story but I can't use the standard scheduler service. I issued the set
commands to setup the environment variables but I'm getting the following
error when the bat file is started via at:
ANS0101E NLInit: Unable to open message repository 'dscameng.txt'.
If I run the same bat file from a DOS prompt it runs fine.
Obviously I don't understand everything I should about at. Does anyone have
an example of doing this?
Curt Magura
Lockheed Martin EIS
Gaithersburg, Md.
301-240-6305
|
|
|