Reclaim thresholds
2015-10-04 17:31:35
I'm starting to run into a problem on reclaims and I'm looking for
suggestions.
I use Quantum DLT-7000 drives, and my data seems to compress well. I now
have off-site copy volumes that should be reclaimed. How do I indicate that
I want reclamation done on the volumes that are less than 50% full (and at
35 GB) (less than 17 GB to reclaim) but NOT reclaim the volumes that are
between 25 and 40% full (and at 100+ GB) (25 to 40+ GB to reclaim).
If I set maxcap for the device class, does ADSM stop writing at maxcap?
According to the on-line help, maxcap must be less than 64 GB; I've hit 115
GB on these tapes and (for assorted reasons) don't want to limit them to 64
GB.
Or do I just give up on ADSM reclaim and write some scripts to do move data
commands against off-site tapes with less than 20 GB on them?
TIA
Tom Kauffman
NIBCO, Inc
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re: Reclaim thresholds, (continued)
- Re: Reclaim thresholds, Slaughter, Bill
- Re: Reclaim thresholds, Larry Way
- Re: Reclaim thresholds, John Sorensen
- Re: Reclaim thresholds, Lindsay Morris
- Re: Reclaim thresholds, Kronstadt, Dan
- Re: Reclaim thresholds, Richard Sims
- Re: Reclaim thresholds, Remeta, Mark
- Re: Reclaim thresholds, Richard Sims
- Re: Reclaim thresholds, John Sorensen
- Reclaim thresholds, Kauffman , Tom [mailto:KauffmanT
- Reclaim thresholds,
ADSM : Dist Stor Manager [mailto:ADSM-L <=
- Re: Reclaim thresholds, Kelly Lipp [mailto:lipp
- Re: Reclaim thresholds, Slaughter , Bill [SMTP:BillSlaughter
- Re: Reclaim thresholds, Richard Sims [mailto:rbs
- Re: Reclaim thresholds, ADSM : Dist Stor Manager [mailto:ADSM-L
|
|
|