Hi Kelly,

Try appending a backslash to the end of the source and
destination filespec, i.e.:

   restore backupset c:\adsmtest\4435323.ost -loc=file
      c:\winnt\ c:\wintest\ -subdir=yes

Best regards,

Andy

Andy Raibeck
IBM Storage Systems Division
ADSM Client Development
e-mail: storman AT us.ibm DOT com
"The only dumb question is the one that goes unasked."

This is cool, by the way.

I'm trying to restore a partial backup set rather than the whole thing.  My
command syntax is:

restore backupset c:\adsmtest\4435323.ost -loc=file c:\winnt
c:\wintest -subdir=yes

My goal is to restore the winnt path to wintest.  I'm getting two files
restored and that's it and not to the correct place either.  I can do a
full
restore of this set using the GUI.

I also notice that the GUI does not allow for partial restores.  Will the
GUI in a future release allow for partial restores?

Did I mention this is cool?  The ability to generate a backupset, move it
to
the client and do a restore without the server is all right!

Kelly J. Lipp
Storage Solutions Specialists, Inc.
PO Box 51313
Colorado Springs CO 80949
719-531-5926
www.storsol.com
lipp AT storsol DOT com