Hi Everybody !
We have a couple of problems with our spectra logic tape
library model
10000-20(slots) with 2 AIT drives and a barcode reader. The
device has a 10 Inch touchscreen
with several menus and functions that appealed to me. Even
though the WWW page says this device is supported using the BASE device
support ADSM 3.1.2.0 required advanced device
support. Without ADS we where able to label tapes but
could not check them in. Labeling tapes with the
labelsource=barcode option GUI or any other command to read the
barcode
with ADSM did result with a "no barcodes
available" message. The library reads the barcodes and I can
see the barcodes
on the touchscreen. We are using 6 digit barcodes and they are
the right barcodes for the device.
Is there another user on this list with a similar device
?
I have labeled the tapes the same as the barcodes when I
checked them in so I can check their position with the librarys touchscreen. AUDIT LIBRARY loaded all the cartridges and read the label
on the tape.
NOT VERY NICE !!!!
We have logged a call with IBM and Spectra Logic regarding
this problem.
Can anybody help me with this problem?
Thank you in advance
Leo Humar
------=_NextPart_000_0095_01BE18CA.E4D1D5D0--
======================================================================= |