Joel,
Try querying the filespace in detailed mode. For example:
adsm> q file RMEQUIP / f=d
If you only see one, try:
adsm> q file RMEQUIP f=d
And see if you have multiple listings, and what - if anything - is
different. I'd pay special attention to the "platform" and "filespace
type" fields.
Not sure what to do once you've found out what's going on though! Good
luck!
Hope this helps a teensy bit,
-Scott
________________________________________________________________________
________________________________________________________________________
L. Scott Emmons | CableData R&D Center - El Dorado Hills, CA, USA
Staff Software Engineer| Unix Administration, Systems Development Dept
(916) 939-6088 | Views and content are my own, not CableData's
>-----Original Message-----
>From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU]On Behalf Of
>Joel Fuhrman
>Sent: Thursday, June 25, 1998 12:16 AM
>To: ADSM-L AT VM.MARIST DOT EDU
>Subject: query occupancy odd output
>
>
>Why would I see the same file system repeated twice for the
>same host as
>output from a "query occupancy"?
>
>ADSM> query occ rmequip
>(header exlcuded)
>RMEQUIP Bkup / BACKUPPOOL 453
>1,686.56 1,686.02
>RMEQUIP Bkup / BACKUPPOOL 786
>4.07 3.70
>(similar duplication is repeated for other file systems)
>
>Does this occur if do a backup from the baclient and then start doing
>backups using the scheduler? Or is it because some of the
>backups were done
>on ADSM version 3.1.1.1 and the others on 3.1.1.3?
>
>Any thoughts as to why they are treated separately. I am
>using the released
>policy and management classes.
>
|