Are you using NetWare for SAA on this system? If so, did you start SAA up
before trying to start ADSM? You need to be sure to load COMMEXEC.NLM,
NWSAA.NLM, CPIC_SAA.NLM (at least I think those are the NLMs, if I remember
correctly).

Andy Raibeck
ADSM Level 2 Support

        ADSM-L AT VM.MARIST DOT EDU
        11-25-97 02:35 PM
Please respond to ADSM-L AT VM.MARIST DOT EDU @ internet

To: ADSM-L AT VM.MARIST DOT EDU @ internet
cc:
Subject: Novell 4.11 and public symbols?

Hi,

I've had this message coming up all of a sudden,
and our Novell guy says they have not installed
any software, or made any changes to the
server...

The backup still worked fine up to 22/11/1997,
but now when you try and load dsmc it comes up
with
the following message:
SERVER-4.11 - 1586: Loader cannot find public
symbol: cmaccp
it gives this message for about 30 variables that
start with cm*

Has anyone seen something like this before?
The dsmc module does not even load after these
messages.

Thanks for any help!

Regards
Christo Heuër
ABSA Group
Johannesburg
South Africa
E-Mail: christoh AT absa.co DOT za