NW 4.1, ADSM cmd with (CLIB_OPT)
1997-04-29 12:40:40
I'm trying to capture some output from an ADSM command on a
Novell NW 4.1 client:
load dsmc q ba -ina -dirsonly -scrollprompt=no srvr\vol:/path
(CLIB_OPT)/>targetpath
I receive the following message:
CLib-4.11-005: Unable to open standard consoles new thread
group. There may not be enough server memory, or server
memory may be corrupted.
The client closes my session with this message:
Server-4.10-2715; Module did not release 240 resources;
Module: ADSM; Resource: Small memory allocation;
Description: Allocated memory byes.
This particular server has 96MB ram, so I tried it on one with
160MB and received the same messages.
I can run the command without the CLIB piece and it outputs to
my screen just fine, but I'm not at all familiar with how
CLIB_OPT works and neither is our NetWare person. Are these
messages giving me the real scoop? Has anyone used it with
success on clients with a similar amount of memory? Any
ideas?
(The ADSM server is a 59H with AIX 4.1.4 and ADSM 2.1.10.)
--Diane
diane.ashby AT toro DOT com
diane.ashby AT toro DOT com
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- NW 4.1, ADSM cmd with (CLIB_OPT),
Diane Ashby <=
|
|
|