I have a question on the Copy Storage PoolL, I am trying to perform  some
of Version 2 features and currently working on the COPY Storage Pool.

I recently created this storage pool and issued the backup storage pool
command through my Admin. Command schedule to backup the tape
pool.  This produced one tape, the same number that is in the backup
pool.   I want this tape from the Copy Storage Pool to go off-site
automatically.   I did not find the information on this Copy Storage Pool
very helpful ,perhaps I missed something so here goes my questions:

Questions:

How do you use this command ACCESS=OFFSITE, I did notice that it
access offsite and location is under the Storage Pool Volume Icon for my
Copy Storage Pool.  Does this mean that I have to manually mark this to
go offsight?  Currently, I  have not put anything in either the location or
offsite area, if I mark those, would that mean all current tapes going to
this would be marked offsite or only this one?  If that is the case, can a
command in the Admin. schedule do this.

I was hoping that it would mark these by itself.  Once marked, how
would one communicate to a 'pulllist' so to speak, like you would in a
Mainframe environment with CA1 to place these volumes in an offsite
listing to go to your Storage building.

Any suggestions would be appreciated.   Thanks, Jane