Author: Zlatko Krastev/ACIT <acit AT ATTGLOBAL DOT NET>
Date: Thu, 6 Feb 2003 08:58:57 +0200
Henry, sorry for delayed answer (have been on a training and was unable to read all mail on time). As expected you did not changed the adapter (to handle larger blocks for tape operations). Look at m
Zlatko (et al), I'm not sure that info in the redbook applies any longer...I wrote that particular piece, and although it was valid at the time, remember that it was written for the 4.1 TSM code/firm
Author: Zlatko Krastev/ACIT <acit AT ATTGLOBAL DOT NET>
Date: Fri, 7 Feb 2003 10:57:43 +0200
Jose, The redbook is dated 14.12.2000 and I cannot recall when 6228 went out. It either was brand new or was not available. Thus was not cited in the redbook. But you are absolutely correct - it appl
Author: Zlatko Krastev/ACIT <acit AT ATTGLOBAL DOT NET>
Date: Sun, 23 Feb 2003 01:01:32 +0200
Lloyd, Unless proved otherwise I will assume it still applies. Whenever I've installed TSM in a SAN I've changed this and had not problems. So practically it is proven. From theoretical side it also
Author: Henrry Aranda <harango AT HOTMAIL DOT COM>
Date: Fri, 24 Jan 2003 15:46:12 -0500
Hi, I have the following environment: TSM Server 5.1.5.2 on AIX 5.1, a FC Adapter 6228 and an IBM LTO 3583 with SANDataGateway. When the library is performing an intensive write process, I get the fo
Author: Kurt Beyers <kurt.beyers AT PANDORA DOT BE>
Date: Fri, 24 Jan 2003 21:57:33 +0100
Henry, I had similar poblems when copying from tape to tape, especially with large files (> 1 GB). I've solved it by changing the SCSI chain (two SCSI controllers in TSM server). It was first SCSI1-d
Author: Henrry Aranda <harango AT HOTMAIL DOT COM>
Date: Fri, 24 Jan 2003 16:56:28 -0500
Kurt, I used two of the four SCSI chains from the SDG, the first chain for the robot and the second chain for the drives, like IBM recommends in its web in the document "Recabling SDG". But this proc
Author: Zlatko Krastev/ACIT <acit AT ATTGLOBAL DOT NET>
Date: Mon, 27 Jan 2003 13:07:12 +0200
Henrry, did you changed the settings for the FC HBA? Can you provide the output of AIX command "lsattr -El fcs0" (or fcsN if you have more HBAs)? Also level of library firmware and drives microcode m
Author: Henrry Aranda <harango AT HOTMAIL DOT COM>
Date: Wed, 29 Jan 2003 16:01:52 -0500
Zlatko No, I did not changed any settings for the FC HBA. The output of the AIX command "lsattr -El fcsN" are the following: - For fcs0 bus_intr_lvl 20 Bus interruptlevel False intr_priority 3 Interr