Author: "Jose A. Hernandez" <Jose_A._Hernandez AT CANDLE DOT COM>
Date: Thu, 11 Jul 1996 15:26:13 PST
I currently have my clients going to a storage pool called CARTRIDGE and would like to move their current data to a DASD storage pool. I read about the MOVE DATA command but you cannot specify a node
Author: "Jose A. Hernandez" <Jose_A._Hernandez AT CANDLE DOT COM>
Date: Mon, 15 Jul 1996 14:10:49 PST
I currently have my clients going to a storage pool called CARTRIDGE and would like to move their current data to a DASD storage pool. I have read about the MOVE DATA command but you cannot specify a
Author: "Pittson, Timothy ,Corp,US" <tpittson AT HIMAIL.HCC DOT COM>
Date: Tue, 16 Jul 1996 17:15:57 -0400
Unfortunately, the Move DATA command cannot be restricted by Nodename - only way to do this would be to have collocation enabled, then determine what client is using each tape and issue the MOVE DATA
Author: "Craig, Ronnie" <RCRA467 AT CSD.CPA.STATE.TX DOT US>
Date: Wed, 17 Jul 1996 08:21:00 CST
Jose, Instead of using the Q content command to figure out which volumes are associated with a particular nodename try using the following command (show volumeusage nodename) where nodename is plug i
Author: Claudia Masters <cmaster1 AT TUELECTRIC DOT COM>
Date: Wed, 17 Jul 1996 13:47:19 -0500
The show command is perfect since we are using collocation and would like to get a list of tapes required to restore a single node. Which manual has the documentation for this command?